200 Amp Automatic Transfer Switch (HTS-N)

This product makes the difference between a truly automatic generator set and just another generator. When the power goes out, this switch automatically senses the failure, turns on your generator, and routes electricity to the circuits of your home. No toggles to flip, no knobs to turn, no extension cords to run during a blackout. You will have the comfort and peace-of-mind knowing that your Guardian stand-by generator does everything for you...automatically!

Features:

• Single coil design, electrically operated and mechanically held
• Programmable exercise time
• SPDT aux contacts
• Main contacts are silver alloy
• Conformal coating protects the printed circuit board
• UL 1008 listed
• Indicating LED's for switch position, standby operating, and utility available
• 3 positions test switch: Fast test, auto, normal test
• Arc chutes on main contacts
• Signal before transfer contacts
• Rated to all classes of loads
• Remote start, stop and transfer through GenLink Communications Software

Specifications:

• Designed to operate in conjunction with the Generac H100 Series generator controller
• 2-wire RS485 communication link to the generator controller
• Switch operation is instigated by the generator controller
• All timers and voltage set points are programmable through GenLink Communications Software
• Standby Accept Voltage: 85-95%
• Standby Accept Frequency: 85-95%
• Nominal Voltage: 1 Volt Increments
• Allowable Deviation of Utility: 1 - 100%
• Line Interruption Delay: 1 - 10 seconds
• Engine Warmup Time: 1 - 300 seconds
• Minimum Run Time: 5 - 60 min.
• Return to Utility Timer: 1 - 30 min.
• Engine Cooldown Timer: 1 - 30 min.
• Signal Before Transfer Timer: 1 - 30 sec.
• Transfer Type: Inphase Time Delay Neutral
• Terminal Lug Wire Contact Terminals: 400MCM - 4 AWG
• Number of Lugs: 4
• Maximum RMS Symmetrical Faul Current: Fuse - 200,000 Amps, Circuit Breaker - 25,000
• Maximum Fuse Size: 400 Amps
• Fuse Class: J, T